Network Working Group T. Howes
Request for Comments: 2891 Loudcloud
Category: Standards Track M. Wahl
Sun Microsystems
A. Anantha
Microsoft
August 2000
LDAP Control Extension for Server Side Sorting of Search Results
Status of this Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2000). All Rights Reserved.
Abstract
This document describes two LDAPv3 control extensions for server side
sorting of search results. These controls allows a client to specify
the attribute types and matching rules a server should use when
returning the results to an LDAP search request. The controls may be
useful when the LDAP client has limited functionality or for some
other reason cannot sort the results but still needs them sorted.
Other permissible controls on search operations are not defined in
this extension.
The sort controls allow a server to return a result code for the
sorting of the results that is independent of the result code
returned for the search operation.
The key words "MUST", "SHOULD", and "MAY" used in this document are
to be interpreted as described in [bradner97].
Howes, et al. Standards Track [Page 1]
RFC 2891 LDAP Control Extension for Server Side Sorting August 2000
1. The Controls
1.1 Request Control
This control is included in the searchRequest message as part of the
controls field of the LDAPMessage, as defined in Section 4.1.12 of
[LDAPv3].
The controlType is set to "1.2.840.113556.1.4.473". The criticality
MAY be either TRUE or FALSE (where absent is also equivalent to
FALSE) at the client's option. The controlValue is an OCTET STRING,
whose value is the BER encoding of a value of the following SEQUENCE:
SortKeyList ::= SEQUENCE OF SEQUENCE {
attributeType AttributeDescription,
orderingRule [0] MatchingRuleId OPTIONAL,
reverseOrder [1] BOOLEAN DEFAULT FALSE }
The SortKeyList sequence is in order of highest to lowest sort key
precedence.
The MatchingRuleId, as defined in section 4.1.9 of [LDAPv3], SHOULD
be one that is valid for the attribute type it applies to. If it is
not, the server will return inappropriateMatching.
Each attributeType should only occur in the SortKeyList once. If an
attributeType is included in the sort key list multiple times, the
server should return an error in the sortResult of
unwillingToPerform.
If the orderingRule is omitted, the ordering MatchingRule defined for
use with this attribute MUST be used.
Any conformant implementation of this control MUST allow a sort key
list with at least one key.
1.2 Response Control
This control is included in the searchResultDone message as part of
the controls field of the LDAPMessage, as defined in Section 4.1.12
of [LDAPv3].
The controlType is set to "1.2.840.113556.1.4.474". The criticality
is FALSE (MAY be absent). The controlValue is an OCTET STRING, whose
value is the BER encoding of a value of the following SEQUENCE:
Howes, et al. Standards Track [Page 2]
RFC 2891 LDAP Control Extension for Server Side Sorting August 2000
SortResult ::= SEQUENCE {
sortResult ENUMERATED {
success (0), -- results are sorted
operationsError (1), -- server internal failure
timeLimitExceeded (3), -- timelimit reached before
-- sorting was completed
strongAuthRequired (8), -- refused to return sorted
-- results via insecure
-- protocol
adminLimitExceeded (11), -- too many matching entries
-- for the server to sort
noSuchAttribute (16), -- unrecognized attribute
-- type in sort key
inappropriateMatching (18), -- unrecognized or
-- inappropriate matching
-- rule in sort key
insufficientAccessRights (50), -- refused to return sorted
-- results to this client
busy (51), -- too busy to process
unwillingToPerform (53), -- unable to sort
other (80)
},
attributeType [0] AttributeDescription OPTIONAL }
2. Client-Server Interaction
The sortKeyRequestControl specifies one or more attribute types and
matching rules for the results returned by a search request. The
server SHOULD return all results for the search request in the order
specified by the sort keys. If the reverseOrder field is set to TRUE,
then the entries will be presented in reverse sorted order for the
specified key.
There are six possible scenarios that may occur as a result of the
sort control being included on the search request:
1 - If the server does not support this sorting control and the
client specified TRUE for the control's criticality field, then
the server MUST return unavailableCriticalExtension as a return
code in the searchResultDone message and not send back any other
results. This behavior is specified in section 4.1.12 of
[LDAPv3].
2 - If the server does not support this sorting control and the
client specified FALSE for the control's criticality field, then
the server MUST ignore the sort control and process the search
request as if it were not present. This behavior is specified in
section 4.1.12 of [LDAPv3].
Howes, et al. Standards Track [Page 3]
RFC 2891 LDAP Control Extension for Server Side Sorting August 2000
3 - If the server supports this sorting control but for some reason
cannot sort the search results using the specified sort keys and
the client specified TRUE for the control's criticality field,
then the server SHOULD do the following: return
unavailableCriticalExtension as a return code in the
searchResultDone message; include the sortKeyResponseControl in
the searchResultDone message, and not send back any search result
entries.
4 - If the server supports this sorting control but for some reason
cannot sort the search results using the specified sort keys and
the client specified FALSE for the control's criticality field,
then the server should return all search results unsorted and
include the sortKeyResponseControl in the searchResultDone
message.
5 - If the server supports this sorting control and can sort the
search results using the specified sort keys, then it should
include the sortKeyResponseControl in the searchResultDone
message with a sortResult of success.
6 - If the search request failed for any reason and/or there are no
searchResultEntry messages returned for the search response, then
the server SHOULD omit the sortKeyResponseControl from the
searchResultDone message.
The client application is assured that the results are sorted in the
specified key order if and only if the result code in the
sortKeyResponseControl is success. If the server omits the
sortKeyResponseControl from the searchResultDone message, the client
SHOULD assume that the sort control was ignored by the server.
The sortKeyResponseControl, if included by the server in the
searchResultDone message, should have the sortResult set to either
success if the results were sorted in accordance with the keys
specified in the sortKeyRequestControl or set to the appropriate
error code as to why it could not sort the data (such as
noSuchAttribute or inappropriateMatching). Optionally, the server MAY
set the attributeType to the first attribute type specified in the
SortKeyList that was in error. The client SHOULD ignore the
attributeType field if the sortResult is success.
The server may not be able to sort the results using the specified
sort keys because it may not recognize one of the attribute types,
the matching rule associated with an attribute type is not
applicable, or none of the attributes in the search response are of
these types. Servers may also restrict the number of keys allowed in
the control, such as only supporting a single key.
Howes, et al. Standards Track [Page 4]
RFC 2891 LDAP Control Extension for Server Side Sorting August 2000
Servers that chain requests to other LDAP servers should ensure that
the server satisfying the client's request sort the entire result set
prior to sending back the results.
2.1 Behavior in a chained environment
If a server receives a sort request, the client expects to receive a
set of sorted results. If a client submits a sort request to a server
which chains the request and gets entries from multiple servers, and
the client has set the criticality of the sort extension to TRUE, the
server MUST merge sort the results before returning them to the
client or MUST return unwillingToPerform.
2.2 Other sort issues
An entry that meets the search criteria may be missing one or more of
the sort keys. In that case, the entry is considered to have a value
of NULL for that key. This standard considers NULL to be a larger
value than all other valid values for that key. For example, if only
one key is specified, entries which meet the search criteria but do
not have that key collate after all the entries which do have that
key. If the reverseOrder flag is set, and only one key is specified,
entries which meet the search criteria but do not have that key
collate BEFORE all the entries which do have that key.
If a sort key is a multi-valued attribute, and an entry happens to
have multiple values for that attribute and no other controls are
present that affect the sorting order, then the server SHOULD use the
least value (according to the ORDERING rule for that attribute).
3. Interaction with other search controls
When the sortKeyRequestControl control is included with the
pagedResultsControl control as specified in [LdapPaged], then the
server should send the searchResultEntry messages sorted according to
the sort keys applied to the entire result set. The server should not
simply sort each page, as this will give erroneous results to the
client.
The sortKeyList must be present on each searchRequest message for the
paged result. It also must not change between searchRequests for the
same result set. If the server has sorted the data, then it SHOULD
send back a sortKeyResponseControl control on every searchResultDone
message for each page. This will allow clients to quickly determine
if the result set is sorted, rather than waiting to receive the
entire result set.
Howes, et al. Standards Track [Page 5]
RFC 2891 LDAP Control Extension for Server Side Sorting August 2000
4. Security Considerations
Implementors and administrators should be aware that allowing sorting
of results could enable the retrieval of a large number of records
from a given directory service, regardless of administrative limits
set on the maximum number of records to return.
A client that desired to pull all records out of a directory service
could use a combination of sorting and updating of search filters to
retrieve all records in a database in small result sets, thus
circumventing administrative limits.
This behavior can be overcome by the judicious use of permissions on
the directory entries by the administrator and by intelligent
implementations of administrative limits on the number of records
retrieved by a client.
5. References
[LDAPv3] Wahl, M, Kille, S. and T. Howes, "Lightweight Directory
Access Protocol (v3)", RFC 2251, December 1997.
[Bradner97] Bradner, S., "Key Words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[LdapPaged] Weider, C., Herron, A., Anantha, A. and T. Howes, "LDAP
Control Extension for Simple Paged Results Manipulation",
RFC 2696, September 1999.
Howes, et al. Standards Track [Page 6]
RFC 2891 LDAP Control Extension for Server Side Sorting August 2000
6. Authors' Addresses
Anoop Anantha
Microsoft Corp.
1 Microsoft Way
Redmond, WA 98052
USA
Phone: +1 425 882-8080
EMail: anoopa@microsoft.com
Tim Howes
Loudcloud, Inc.
615 Tasman Dr.
Sunnyvale, CA 94089
USA
EMail: howes@loudcloud.com
Mark Wahl
Sun Microsystems, Inc.
8911 Capital of Texas Hwy Suite 4140
Austin, TX 78759
USA
EMail: Mark.Wahl@sun.com
Howes, et al. Standards Track [Page 7]
RFC 2891 LDAP Control Extension for Server Side Sorting August 2000
7. Full Copyright Statement
Copyright (C) The Internet Society (2000). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Howes, et al. Standards Track [Page 8]