This is version 029 of the new AX.25 and NET/ROM code for Linux. It
incorporates many enhancements since the last release, notably the rewriting
of the connected mode IP code and the IP over NET/ROM code. The opportunity
has been taken to add the G8BPQ NET/ROM extensions and to add BPQ Ethernet
support. The latter has been much eased by the use of the new variable
length header code by Alan Cox.

To use the BPQ Ethernet option, first up the ethernet interface in the usual
manner, the IP address of the interface is not that important but it will
be required for the ARP table. Next create an ARP entry in the ARP table of
type ax25 for the interface binding it to an AX.25 callsign, this callsign
will be the callsign of that interface. By default BPQ Ethernet uses a
multi-cast address, this implementation does not, instead the standard
ethernet broadcast address is used. Therefore the NET.CFG file for the
ODI driver should look similar to this:

------------------------------ cut here ------------------------------------

LINK SUPPORT

	MAX STACKS 1
	MAX BOARDS 1

LINK DRIVER E2000			; or other MLID to suit your card

	INT 10				;
	PORT 300			; to suit your card

	FRAME ETHERNET_II

	PROTOCOL BPQ 8FF ETHERNET_II	; required for BPQ - can change PID

BPQPARMS				; optional - only needed if you want
					; to override the default target addr

	ETH_ADDR  FF:FF:FF:FF:FF:FF	; Target address

----------------------------- cut here -------------------------------------

The above configuration assumes that only BPQ Ethernet is being used.

It is not possible to run IP over AX.25 on the BPQ Ethernet port. To simply
route IP frames to (say) eth0 would create standard ethernet IP frames and
completely bypass the AX.25 code. However it is possible to use IP over
NET/ROM across a BPQ Ethernet link, the performance of such a system is
very acceptable indeed.

Jonathan Naylor G4KLX

g4klx@amsat.org