patch-2.4.23 linux-2.4.23/arch/ppc/platforms/ocotea.h

Next file: linux-2.4.23/arch/ppc64/boot/addRamDisk.c
Previous file: linux-2.4.23/arch/ppc/platforms/ocotea.c
Back to the patch index
Back to the overall index

diff -urN linux-2.4.22/arch/ppc/platforms/ocotea.h linux-2.4.23/arch/ppc/platforms/ocotea.h
@@ -0,0 +1,84 @@
+/*
+ * arch/ppc/platforms/ocotea.h
+ *
+ * Ocotea board definitions
+ *
+ * Matt Porter <mporter@mvista.com>
+ *
+ * Copyright 2003 MontaVista Software Inc.
+ *
+ * This program is free software; you can redistribute  it and/or modify it
+ * under  the terms of  the GNU General  Public License as published by the
+ * Free Software Foundation;  either version 2 of the  License, or (at your
+ * option) any later version.
+ *
+ */
+
+#ifdef __KERNEL__
+#ifndef __ASM_OCOTEA_H__
+#define __ASM_OCOTEA_H__
+
+#include <linux/config.h>
+#include <platforms/ibm440gx.h>
+
+/* F/W TLB mapping used in bootloader glue to reset EMAC */
+#define PPC44x_EMAC0_MR0	0xE0000800
+
+/* Location of MAC addresses in firmware */
+#define OCOTEA_MAC_BASE		(OCOTEA_SMALL_FLASH_HIGH+0xc0500)
+#define OCOTEA_MAC_SIZE		0x200
+#define OCOTEA_MAC1_OFFSET	0x100
+
+/* Default clock rate */
+#define OCOTEA_SYSCLK		25000000
+
+/* RTC/NVRAM location */
+#define OCOTEA_RTC_ADDR		0x0000000148000000ULL
+#define OCOTEA_RTC_SIZE		0x2000
+
+/* Flash */
+#define OCOTEA_FPGA_ADDR		0x0000000148300000ULL
+#define OCOTEA_BOOT_LARGE_FLASH(x)	(x & 0x40)
+#define OCOTEA_SMALL_FLASH_LOW		0x00000001ff900000ULL
+#define OCOTEA_SMALL_FLASH_HIGH		0x00000001fff00000ULL
+#define OCOTEA_SMALL_FLASH_SIZE		0x100000
+#define OCOTEA_LARGE_FLASH_LOW		0x00000001ff800000ULL
+#define OCOTEA_LARGE_FLASH_HIGH		0x00000001ffc00000ULL
+#define OCOTEA_LARGE_FLASH_SIZE		0x400000
+
+/*
+ * Serial port defines
+ */
+#define RS_TABLE_SIZE	2
+
+/* OpenBIOS defined UART mappings, used before early_serial_setup */
+#define UART0_IO_BASE	(u8 *) 0xE0000200
+#define UART1_IO_BASE	(u8 *) 0xE0000300
+
+#define BASE_BAUD	11059200/16
+#define STD_UART_OP(num)					\
+	{ 0, BASE_BAUD, 0, UART##num##_INT,			\
+		(ASYNC_BOOT_AUTOCONF | ASYNC_SKIP_TEST),	\
+		iomem_base: UART##num##_IO_BASE,		\
+		io_type: SERIAL_IO_MEM},
+
+#define SERIAL_PORT_DFNS	\
+	STD_UART_OP(0)		\
+	STD_UART_OP(1)
+
+/* PCI support */
+#define OCOTEA_PCI_LOWER_IO	0x00000000
+#define OCOTEA_PCI_UPPER_IO	0x0000ffff
+#define OCOTEA_PCI_LOWER_MEM	0x80000000
+#define OCOTEA_PCI_UPPER_MEM	0xffffefff
+
+#define OCOTEA_PCI_CFGREGS_BASE	0x000000020ec00000ULL
+#define OCOTEA_PCI_CFGA_PLB32	0x0ec00000
+#define OCOTEA_PCI_CFGD_PLB32	0x0ec00004
+
+#define OCOTEA_PCI_IO_BASE	0x0000000208000000ULL
+#define OCOTEA_PCI_IO_SIZE	0x00010000
+#define OCOTEA_PCI_MEM_OFFSET	0x00000000
+
+#endif				/* __ASM_OCOTEA_H__ */
+#endif				/* __KERNEL__ */

FUNET's LINUX-ADM group, linux-adm@nic.funet.fi
TCL-scripts by Sam Shen (who was at: slshen@lbl.gov)