patch-2.2.15 linux/Documentation/sound/ALS007

• Lines: 41
• Date: Thu Jan 1 01:00:00 1970
• Orig file: v2.2.14/Documentation/sound/ALS007
• Orig date: Fri Jul 10 22:03:35 1998

diff -u --new-file --recursive --exclude-from ../../exclude v2.2.14/Documentation/sound/ALS007 linux/Documentation/sound/ALS007
@@ -1,40 +0,0 @@
-ALS-007 based sound cards
-=========================
-
-Support for sound cards based around the Avance Logic ALS-007 chip is
-included.  The ALS-007 is a single chip PnP sound solution which is mostly
-hardware compatible with the Sound Blaster 16 card, with most differences
-occurring in the use of the mixer registers.  For this reason the ALS-007 
-code is integrated as part of the Sound Blaster 16 driver (adding only 800
-bytes to the SB16 driver).
-
-To use an ALS-007 sound card under Linux, enable the following options in the
-sound configuration section of the kernel config:
-  - 100% Sound Blaster compatibles (SB16/32/64, ESS, Jazz16) support
-  - FM synthesizer (YM3812/OPL-3) support 
-Since the ALS-007 is a PnP card, the sound driver probably should be
-compiled as a module, with the isapnptools used to wake up the sound card.
-Set the "I/O base for SB", "Sound Blaster IRQ" and "Sound Blaster DMA" (8 bit -
-either 0, 1 or 3) to the values used in your particular installation (they
-should match the values used to configure the card using isapnp).  The
-ALS-007 does NOT implement 16 bit DMA, so the "Sound Blaster 16 bit DMA"
-should be set to -1.  If you wish to use the external MPU-401 interface on
-the card, "MPU401 I/O base of SB16" and "SB MPU401 IRQ" should be set to
-the appropriate values for your installation.  (Note that the ALS-007
-requires a separate IRQ for the MPU-401, so don't specify -1 here).  (Note
-that the base port of the internal FM synth is fixed at 0x388 on the ALS007; 
-in any case the FM synth location cannot be set in the kernel configuration).
-
-The resulting sound driver will provide the following capabilities:
-  - 8 and 16 bit audio playback
-  - 8 and 16 bit audio recording
-  - Software selection of record source (line in, CD, FM, mic, master)
-  - Record and playback of midi data via the external MPU-401
-  - Playback of midi data using inbuilt FM synthesizer
-  - Control of the ALS-007 mixer via any OSS-compatible mixer programs. 
-    Controls available are Master (L&R), Line in (L&R), CD (L&R), 
-    DSP/PCM/audio out (L&R), FM (L&R) and Mic in (mono).
-
-Jonathan Woithe
-jwoithe@physics.adelaide.edu.au
-30 March 1998